Changing The Engine Oil; Lubricating The Wheel Gears; Adjusting The Self-Propel Drive - Lawn-Boy Insight 10684 Operator's Manual

Changing the Engine Oil

Change the engine oil after the first 2 operating
hours; change it yearly thereafter.
Run the engine a few minutes before changing the oil
to warm it. Warm oil flows better and carries more
contaminants.
Refer to Preparing for Maintenance on page 12.
1. Remove the
dipstick.
2. Tip the mower onto
its side (with the air filter
up) to drain the used oil
out through the oil fill
tube.
3. Slowly pour oil into
the oil fill tube until the
oil level reaches the Full
line on the dipstick. Do
not overfill. (Max. fill:
20 oz., type: SAE 30W
detergent oil with an API
service classification of
SF, SG, SH, SJ, SL, or
higher.)
4. Install the dipstick securely.
5. Dispose of the used oil properly at a local
recycling center.
m-7921/m-5571
m-7938
m-7921/m-5571
3352-935 Rev B
13
Lubricating the Wheel
Gears
1. Remove the wheel bolt in the center of each rear
wheel and remove the rear wheels.
2. Apply a lubricating
oil to the inner and outer
sides of the gear as
shown.
3. Install the rear wheels.
Adjusting the Self-propel
Drive
If your mower does not self-propel properly, adjust the
self-propel drive cable.
1. Loosen the nut on the cable mount (A).
m-5646a
A