Unfolding The Handle; Installing The Fuse; Filling The Engine With Oil - Lawn-Boy 10666C Operator's Manual

Setup
Important: Remove and discard the protective
plastic sheet that covers the engine.

1. Unfolding the Handle

Procedure
1. Move the handle rearward and hold the upper handle
in place (Figure 3).
2. Tighten the upper handle knob as tight as you can
(Figure 4).

2. Filling the Engine with Oil

Procedure
Your mower does not come with oil in the engine, but it
does come with a bottle of oil.
1. Remove the dipstick (Figure 5).
Figure 3
Figure 4
2. Slowly pour oil into the oil fill tube until the oil
level reaches the Full line on the dipstick (Figure 5).
Do not overfill. (Max. fill: 20 oz., type: SAE 30
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.)
Note: If you overfill the engine, pour some oil out
of it as directed in Changing the Engine Oil.
3. Install the dipstick securely.
Important:
Change the engine oil after the first
5 operating hours
Refer to Changing the Engine Oil.

3. Installing the Fuse

Procedure
Your mower comes with a 40-amp fuse that protects the
electric starter.
Important: You cannot start the mower with the
electric starter or charge the battery unless you
install the fuse.
1. Remove the 2 screws that fasten the battery cover to
the rear of the mower (Figure 6).
6
Figure 5
; change it yearly thereafter.