Lubricating The Wheel Gears; Adjusting The Self-Propel Drive; Lubricating The Upper Handle - Lawn-Boy Insight 10695 Operator's Manual

Lubricating the Wheel
Gears
1. Remove the wheel bolt in the center of each rear
wheel and remove the rear wheels.
2. Apply a lubricating
oil to the inner and outer
sides of the gear as
shown.
3. Install the rear wheels.
Lubricating the Upper
Handle
Lubricate the left and right sides of the upper handle
with a low-viscosity silicone spray lubricant yearly or
as needed.
1. Spray the outer plastic end of the inner handle.
m-8014
Note: Use the straw that comes with the spray
can to direct the spray.
2. Push the upper handle fully down and spray the
inner plastic surface of the outer handle.
m-8014
m-5646a
m-8015
m-8016
3352-951 Rev B
13
Adjusting the Self-propel
Drive
If your mower does not self-propel properly, adjust the
self-propel drive cable.
1. Loosen the nut on the cable mount (A).
2. Pull the upper handle back fully rearward.
Note: If the handle does not move smoothly, refer
to Lubricating the Upper Handle section.
3. Pull the cable jacket downward until you remove
the slack in the exposed cable (B).
A
B