Lawn-Boy 10666C Operator's Manual page 8

1. Top of mulch plug lever in switch channel
1. Insert the mulch plug into the mower, if it isn't
already installed (Figure 10).
Figure 10
2. Squeeze the button on the lever with your thumb
and fully insert the mulch plug into the opening
(Figure 11).
Figure 9
3. Release the button on the lever and ensure that the
top of the lever is lies fully in the switch channel
(Figure 12). If the top of the lever is not in the
switch channel, your mower will not start!
Note: If the lever does not latch properly,
disconnect the wire from the spark plug and check
for and remove any debris buildup in the tunnel.
8
Figure 11
Figure 12