Lubricating The Wheel Gears; Replacing The Fuse; Lubricating The Upper Handle - Lawn-Boy 10666C Operator's Manual

5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
Charging the Battery
Service Interval: Yearly or before storage
Refer to Charge the Battery in the Setup section.

Replacing the Fuse

If the battery does not charge or the engine does not
turn with the electric starter, the fuse may be blown.
Replace it with a 40-amp plug-in type fuse. Refer to
Install the Fuse in the Setup section.
Figure 43

Lubricating the Wheel Gears

Service Interval: Yearly
1. Remove the wheel bolt in the center of each rear
wheel and remove the rear wheels.
2. Apply a lubricating oil to the inner and outer sides
of the gear as shown in Figure 44.
3. Install the rear wheels.

Lubricating the Upper Handle

Service Interval: Yearly
Lubricate the left and right sides of the upper handle
with a low-viscosity silicone spray lubricant yearly or
as needed.
1. Spray the outer plastic end of the inner handle
(Figure 45).
Note: Use the straw that comes with the spray can
to direct the spray.
2. Push the upper handle fully down and spray the
inner plastic surface of the outer handle (Figure 46).
18
Figure 44
Figure 45