Outback Power Systems FLEXnet DC User Manual page 25

ADV/DC/PAGE 1----------------
choose category
ADV BAT
ADV/DC/BAT-------------------
battery capacity
amp hours
TOP INC
ADV/DC/PAGE 1----------------
choose category
ADV BAT
ADV/DC/SHUNT 1 ---------------
shunt 1 mode
DOWN EN
Pressing the <DOWN> soft key
changes the shunt being enabled
or disabled.
ADV/DC/SHUNT-----------------
shunt setup complete
TOP
ADV--------------------------------
choose device:
FX CC
ADV/DC/PAGE 1----------------
choose category
ADV BAT
24
Press the <BAT> soft key.
SHUNT PG2
Use the battery capacity screen to set the battery bank
capacity using either the <INC> or <DEC> soft key. When
DEC ADV
fi nished, press the <TOP> soft key.
Press the <SHUNT> soft key.
SHUNT PG2
Shunt 1 is, by default, enabled or active when the FX is
powered up. Pressing the <DIS> soft key disables the fi rst
DIS TOP shunt. Pressing the <DOWN> soft key leads to the shunt 2
mode and shunt 3 mode screens. These shunts are disabled
at power-up and are enabled by pressing the <EN> soft key.
When the setup for all shunts has been completed, press the
<DOWN> soft key for the next screen.
Press the <ADV> soft key.
ADV MAIN
Press the <DC> soft key.
DC MATE
Press the <PG2> soft key.
SHUNT PG2