Inverter Control - Outback Power Systems Inverter/Charger FX2012ET Installation And Programming Manual

MATE - SYSTEM CONTROLLER AND DISPLAY

Inverter Control

The OutBack MATE includes an INV "hot" key to allow direct control of the inverter from anywhere in the menu system. The INV key is
located on the right side of the MATE LCD display. Pressing the INV key takes you to the INVERTER CONTROL menu shown below.
A green LED indicator is located above the INV key which flashes when the inverter is either in the search or power save modes and is
on continuously when full AC output voltage is available from the FX. When the inverter is turned off the green LED will not be
illuminated.
INV
INVERTER CONTROL
currently: ON
OFF SRCH ON OK
Installation & Programming Manual
Page 32
Pressing the INV key once brings up the INVERTER CONTROL screen. To turn the inverter
ON, press the key located below the word <ON>. Selecting <SRCH> will cause the inverter to
begin operating in the search mode as long as the AC load connected is smaller than allowed by
the programming of the search function. Selecting <OFF> turns off the inverters AC output
signal.
Select <OK> to return to the point in the menu system from where you entered the INVERTER
CONTROL screen.
FX & VFX "E" Series Inverter/Charger System
900-0027-2
Rev 7.1
Copyright 2003
06/08/06
INV
OutBack Power Systems, Inc.
nd
19009 62 Ave NE, Arlington WA 98223 USA
Tel 360 435 6030 Fax 360 435 6019