Table of Contents
Advertisement
[3] Initial mode of the Océ 31x5E Network Copier when set to printing
[4] Initial mode of the Océ 31x5E Network Copier when set to scanning
Scanning is an optional feature. From this point until the end of the
Note:
manual, the display will be shown without a scanning mode.
By factory default, the initial mode displays the basic copy job settings. These
settings are usually defined for making double-sided copies from single-sided
originals on 8.5 x 11" paper from tray 4, with no reduction or enlargement (set
at 100%).
When originals are placed in the automatic document feeder, their size is
detected automatically and the matching paper tray (if available) is selected. If
the size of the original does not match any available paper size, the copier will
select the required reduction or enlargement factor automatically.
This means that the only action required to make a double-sided copy is
pressing the green start button.
The key operator can change any setting to a specific custom value. These
customized settings then become the standard copy settings.
All settings can be changed as required for each new job. Once a job is
completed and a certain number of seconds (pre-set by the key operator) have
passed, the Océ 31x5E returns to initial mode.
Introduction
15
Advertisement
Table of Contents
