Display Latch; Replacing The Display Panel; Removing The Display Latch - Dell Inspiron 9200 Service Manual

5. Remove the eight M2 x 3-mm screws from each side of the display panel.
6. Lift the display panel out of the display cover.
7. Press in both sides of the top flex-cable connector, and pull the top flex-cable connector away from the display connector.
8. Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.
1 pull-tab on bottom flex-cable connector
2 top flex-cable connector
3 display connector
4 inverter connector

Replacing the Display Panel

1. Reconnect the top display cable connector to the top flex-cable connector.
2. Reconnect the bottom flex-cable connector to the inverter connector.
3. Replace the display panel inside the top cover.
4. Replace the M2 x 3-mm ground screw that attaches the display-panel ground wire to the back display cover.
5. Replace the eight M2 x 3 screws (four on each side) around the display panel.
6. Replace the display bezel.
Display Latch

Removing the Display Latch

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
1. Follow the instructions in "Before Working Inside Your
2. Remove the display.
3. Remove the display bezel.
Computer."