Removing The Microprocessor Thermal-Cooling Assembly; Replacing The Microprocessor Thermal-Cooling Assembly - Dell Inspiron 9200 Service Manual

Back to Contents Page
Microprocessor Thermal-Cooling Assembly
Dell™ Inspiron™ 9200
Removing the Microprocessor Thermal-Cooling Assembly
Replacing the Microprocessor Thermal-Cooling Assembly
Removing the Microprocessor Thermal-Cooling Assembly
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.
1. Follow the instructions in "Before Working Inside Your
2. Remove the hinge cover.
3. Remove the keyboard.
4. Remove the display assembly.
5. Remove the palm rest.
6. Loosen in consecutive order the four captive screws, labeled "1" through "4," that secure the microprocessor thermal-cooling assembly to the system
board.
7. Lift up the microprocessor thermal-cooling assembly and remove it from the system board.
1 microprocessor thermal-cooling assembly
2 captive screws (4)
Replacing the Microprocessor Thermal-Cooling Assembly
1. Evenly apply thermal grease to the top surface of the microprocessor.
2. Place the microprocessor thermal-cooling assembly over the microprocessor.
3. Tighten the four captive screws, labeled "1" through "4," in consecutive order.
Computer."