Problems When Projection Starts; Other Problems - Epson EMP-1815 User Manual

Problem Solving

Problems when projection starts

f
f Power does not turn on
Check
Did you press the [Power] button?
Are the indicators switched off?
Do the indicators turn on and off when the power cable is
touched?
Is the operation lock set to "Full Lock"?
Is the correct setting for the remote receiver selected?
Was the power cable plugged back in immediately after
Direct Power Off, or is the breaker turned off?

Other problems

f
f No sound can be heard or the sound is faint
Check
Is the audio source connected correctly?
Is the volume adjusted to the minimum setting?
Is A/V Mute active?
Is the audio cable's specification "No resistance"?
f The remote control does not work
Check
Is the remote control light-emitting area pointing towards the
remote receiver on the projector when it is operated?
Is the remote control too far from the projector?
Downloaded from ProjectorsManual.com Manuals
Press the [Power] button to turn the power on.
The power cable is not connected correctly or power is not being supplied normally.
Connect the projector's power cable correctly. sQuick Start Guide
Check that your electrical outlet or power source is functioning correctly.
There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power
cable. If this does not solve the problem, stop using the projector, disconnect the power cable from the
electrical outlet, and contact your local dealer or the nearest address provided in the World-Wide Warranty
Terms. s Inquiries
Press and hold down the [Enter] button on the control panel for about seven seconds, a message is displayed
and the lock is released. s p.37
Check the "Remote Receiver" from the configuration menu. s"Settings"-"Remote receiver"
When the operation to the left is performed when "Direct Power On" is set to "On", the power may not turn
back on. [Power]Press the button to turn the power back on.
Check that the cable is connected to the Audio port.
Adjust the volume so that sound can be heard. sQuick Start Guide
Press the [A/V Mute] button on the remote control to cancel A/V Mute. s
When using a commercially available audio cable, make sure it is labeled "No resistance".
Point the remote control towards the remote receiver.
The operating angle for the remote control is about 30° horizontally, and about 15° vertically. sQuick Start
Guide
The operating range for the remote control is about 6 m. sQuick Start Guide
Remedy
Remedy
p.23
Remedy
69
p.43