Wireless Lan Menu - Epson EMP-1815 User Manual

List of Functions

Wireless LAN Menu

f
Sub Menu
Connection mode Sets the connection mode.
Set "Quick" to establish a quick wireless connection in a 1:1 configuration. Set "Advanced" to connect to the network system via an access point.
Antenna level
Displays the wireless LAN wave strength.
Wireless LAN Sets the wireless LAN system.
system
g
ESSID Enter an ESSID. When an ESSID is provided for the wireless LAN system in which the projector participates, enter the ESSID. The initial value is
EPSON.
You can enter up to 32 single-byte alphanumeric characters.
DHCP g You can set whether to use DHCP (On) or not (Off).
If this is set to "On" you cannot set any more addresses.
g
IP address You can input the IP address assigned to the projector.
You can enter a number from 0 to 255 in each field of the address. However, the following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Subnet mask g You can input the subnet mask for the projector. You can enter a number from 0 to 255 in each field of the address. However, the following subnet
masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway address g You can input the IP address for the gateway for the projector.
You can enter a number from 0 to 255 in each field of the address. However, the following gateway addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
Downloaded from ProjectorsManual.com Manuals
Function
49