Epson EMP-1815 User Manual page 67

Hide thumbs Also See for EMP-1815:
Table of Contents

Advertisement

Problem Solving
f
Interference or distortion appear in images
Check
Is the image signal format setting correct?
Only when projecting images from a video source
Are the cables connected correctly?
Is an extension cable being used?
Is the correct resolution selected?
Only when projecting computer images
Are the "Sync.
g
" and "Tracking
correctly?
Only when projecting computer images
f
The image is truncated (large) or small, or the aspect is not suitable
Check
Is a wide panel computer image being projected?
Only when projecting computer images
Is the image still being enlarged by E-Zoom?
Is "Position" adjusted correctly?
Is the computer set for dual display?
Only when projecting computer images
Is the correct resolution selected?
Only when projecting computer images
Downloaded from ProjectorsManual.com Manuals
Change the setting according to the signal for the connected equipment. s"Signal"-"Video Signal"
Check that all the cables required for projection are securely connected. sQuick Start Guide
If an extension cable is used, electrical interference may affect the signals. Use the cables supplied with the
projector to check if the cables you are using may be causing the problem.
Set the computer so that the signals being output are compatible with this projector.
s "List of Supported Monitor Displays"
g
" settings adjusted
Press the [Auto] button on the remote control or the [Enter] button on the control panel to perform automatic
adjustment. If the images are not adjusted correctly after using automatic adjustment, you can make the
adjustments using "Sync." and "Tracking" from the configuration menu. s"Signal"-"Tracking", "Sync."
p.42
Press the [Resize] button on the remote control to change the aspect mode in the order of "Normal", "4:3",
and "16:9". Change the aspect mode according to the resolution.
Press the [Esc] button on the remote control to cancel E-Zoom. s
Press the [Auto] button on the remote control or the [Enter] button on the control panel to perform automatic
adjustment of the computer image being projected. If the images are not adjusted correctly after using
automatic adjustment, you can make the adjustments using "Position" from the configuration menu.
Apart from computer image signals, you can adjust other signals while projecting by adjusting "Position"
from the configuration menu. s"Signal"-"Position"
If dual display is activated in the "Display Properties" of the computer's control panel, only about half of the
image on the computer screen is projected. To display the entire image on the computer screen, turn off the
dual display setting. sComputer video driver documentation
Set the computer so that the signals being output are compatible with the projector.
s "List of Supported Monitor Displays"
Remedy
p.92
sComputer documentation
Remedy
p.27
p.42
p.92
sComputer documentation
67
p.42

Advertisement

Table of Contents
loading

This manual is also suitable for:

Emp-1810

Table of Contents