Configuring Ethernet Ports
Setting Ethernet Parameters for All Port Types
The following sections describe how to configure Ethernet port parameters using CLI commands that can
be used on all port types. See
mation on configuring non combo ports and see
for more information on configuring combo ports.
Setting Trap Port Link Messages
The
trap port link
command can be used to enable or disable (the default) trap port link messages on a
specific port, a range of ports, or all ports on a switch (slot). When enabled, a trap message will be
displayed on a Network Management Station (NMS) whenever the port state has changed.
Enabling Trap Port Link Messages
To enable trap port link messages on an entire switch, enter trap followed by the slot number and port
link enable. For example, to enable trap port link messages on all ports on slot 2 enter:
-> trap 2 port link enable
To enable trap port link messages on a single port enter trap followed by the slot number, a slash (/), the
port number, and port link enable. For example, to enable trap port link messages on slot 2 port 3 enter:
-> trap 2/3 port link enable
To enable trap port link messages on a range of ports enter trap followed by the slot number, a
slash (/), the first port number, a hyphen (-), the last port number, and port link enable. For example, to
enable trap port link messages ports 3 through 5 on slot 2 enter:
-> trap 2/3-5 port link enable
Disabling Trap Port Link Messages
To disable trap port link messages on an entire switch, enter trap followed by the slot number and port
link disable. For example, to disable trap port link messages on all ports on slot 2 enter:
-> trap 2 port link disable
To disable trap port link messages on a single port enter trap followed by the slot number, a slash (/), the
port number, and port link disable. For example, to disable trap port link messages on slot 2 port 3 enter:
-> trap 2/3 port link disable
To disable trap port link messages on a range of ports port enter trap followed by the slot number, a
slash (/), the first port number, a hyphen (-), the last port number, and port link disable. For example, to
disable trap port link messages ports 3 through 5 on slot 2 enter:
-> trap 2/3-5 port link disable
OmniSwitch 6800 Series Network Configuration Guide
"Setting Ethernet Parameters for Non Combo Ports" on page 1-13
"Setting Combo Ethernet Port Parameters" on page 1-17
November 2004
Setting Ethernet Parameters for All Port Types
for infor-
page 1-7