Yamaha TDM900 Owner's Manual page 18

INSTRUMENT AND CONTROL FUNCTIONS
Neutral indicator light "
This indicator light comes on when the
transmission is in the neutral position.
1
High beam indicator light "
2
This indicator light comes on when the
high beam of the headlight is switched
on.
3
4
Oil level warning light
This warning light comes on when the
engine oil level is low.
5
The electrical circuit of the warning light
can be checked by turning the key to
6
"ON".
If the warning light does not come on
7
for a few seconds, then go off, have a
Yamaha dealer check the electrical cir-
cuit.
8
NOTE:
Even if the oil level is sufficient, the
9
warning light may flicker when riding on
a slope or during sudden acceleration
or deceleration, but this is not a mal-
function.
EAU11060
" Fuel level warning indicator " "
This fuel level warning indicator starts
flashing when the fuel level drops be-
low approximately 3.5 L (0.92 US gal)
EAU11080 (0.77 Imp.gal).
"
Engine trouble warning light "
This warning light comes on or flashes
when an electrical circuit monitoring the
EAU38600 engine is defective. When this occurs,
have a Yamaha dealer check the
self-diagnosis system.
The electrical circuit of the warning light
can be checked by turning the key to
"ON". If the warning light does not come
on for a few seconds, then go off, have
a Yamaha dealer check the electrical
circuit.
Immobilizer system indicator light
The electrical circuit of the indicator
light can be checked by turning the key
to "ON".
If the indicator light does not come on
for a few seconds, then go off, have a
Yamaha dealer check the electrical cir-
EAU11371 cuit.
When the key is turned to "OFF" and 30
seconds have passed, the indicator
light will start flashing indicating the im-
mobilizer system is enabled. After 24
hours have passed, the indicator light
will stop flashing, however the immobi-
EAU11500
lizer system is still enabled.
"
NOTE:
This model is also equipped with a
self-diagnosis device for the immobiliz-
er system. If the immobilizer system is
defective, the indicator light will start
flashing a pattern and the odometer/
tripmeter will display a 2-digit code
when the key is turned to "ON". When
this occurs, have a Yamaha dealer
check the self-diagnosis system. How-
ever, if the indicator light slowly flashes
five times, and then quickly flashes two
times repeatedly, error code 52 will be
EAU38610
displayed. This error could be caused
by signal interference. If this occurs, try
the following.
1. Use the code re-registering key to
3-4
start the engine.