Replacing The Fuses - Yamaha XMAX 250 YP250R Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
3. Fully charge the battery before
installation.
4. After installation, make sure that
the battery leads are properly
connected to the battery termi-
nals.
CAUTION
Always keep the battery char-
ged. Storing a discharged bat-
tery can cause permanent bat-
tery damage.
To charge a sealed-type (MF)
battery, a special (constant-
voltage) battery charger is
6
required. Using a conventional
battery charger will damage
the battery. If you do not have
access to a sealed-type (MF)
battery charger, have a Yamaha
dealer charge your battery.

Replacing the fuses

ECA10630
The main fuse and the fuse box,
which contains the fuses for the indi-
vidual circuits, are located behind
cowling B. (See page 6-5.)
If a fuse is blown, replace it as
follows.
1. Turn the key to "OFF" and turn off
the electrical circuit in question.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage.
6-19
EAU23610
Specified fuses:
Main fuse
30.0 A
Headlight fuse
15.0 A
Signaling system fuse
15.0 A
Ignition fuse
5.0 A
Radiator fan fuse
10 A
ECU fuse
5.0 A
Backup fuse
5.0 A
Reserve fuse
5.0 A
10 A
15.0 A
30.0 A
CAUTION
Do not use a fuse of a higher ampe-
rage rating than recommended to
avoid causing extensive damage to
the electrical system and possibly a
fire.
ECA10640