Coolant - Yamaha SUPER TENERE XT1200Z Owner's Manual

Tightening torque:
Final gear oil drain bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
5. Refill with the recommended final
gear oil to the brim of the filler hole.
Recommended final gear oil:
Yamaha genuine shaft drive gear oil
SAE 80 API GL-5 or SAE 80 API
GL-4 Hypoid gear oil
Oil quantity:
0.20 L (0.21 US qt, 0.18 Imp.qt)
6. Check the oil filler bolt gasket for
damage, and replace it if neces-
sary.
7. Install the oil filler bolt and its gas-
ket, and then tighten the bolt to the
specified torque.
Tightening torque:
Final gear oil filler bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
8. Check the final gear case for oil
leakage. If oil is leaking, check for
the cause.
PERIODIC MAINTENANCE AND ADJUSTMENT

Coolant

The coolant level should be checked
before each ride. In addition, the cool-
ant must be changed at the intervals
specified in the periodic maintenance
and lubrication chart.
To check the coolant level
1. Place the vehicle on the center-
stand.
TIP
G
The coolant level must be checked
on a cold engine since the level
varies with engine temperature.
G Make sure that the vehicle is posi-
tioned straight up when checking
the coolant level. A slight tilt to the
side can result in a false reading.
2. Check the coolant level in the cool-
ant reservoir.
TIP
The coolant should be between the
minimum and maximum level marks.
6-15
EAU20070
1
EAU40154
1. Coolant reservoir
2. Maximum level mark
3. Minimum level mark
3. If the coolant is at or below the
minimum level mark, remove the
coolant reservoir cap.
1. Coolant reservoir cap
2
3
6
1