Changing The Brake And Clutch Fluids; Drive Chain Slack - Yamaha XJR1300 Owner's Manual

Changing the brake and
clutch fluids
Have a Yamaha dealer change the
brake and clutch fluids at the intervals
specified in the NOTE after the periodic
maintenance and lubrication chart. In
addition, have the oil seals of the brake
and clutch master cylinders and cali-
pers as well as the brake and clutch
hoses replaced at the intervals listed
below or whenever they are damaged
or leaking.
G
Oil seals: Replace every two
years.
G
Brake and clutch hoses: Replace
every four years.
PERIODIC MAINTENANCE AND MINOR REPAIR
EAU22750

Drive chain slack

The drive chain slack should be
checked before each ride and adjusted
if necessary.
To check the drive chain slack
1. Place the motorcycle on the cen-
terstand.
2. Shift the transmission into the neu-
tral position.
3. Spin the rear wheel several times
to locate the tightest portion of the
drive chain.
4. Measure the drive chain slack as
shown.
1. Drive chain slack
EAU22760
5. If the drive chain slack is incorrect,
EAU22791
To adjust the drive chain slack
1. Loosen the axle nut and the lock-
2. To tighten the drive chain, turn the
NOTE:
Using the alignment marks on each
side of the swingarm, make sure that
both chain pullers are in the same posi-
tion for proper wheel alignment.
6-20
Drive chain slack:
20.0–30.0 mm (0.79–1.18 in)
adjust it as follows.
nut on each side of the swingarm.
adjusting bolt on each side of the
swingarm in direction (a). To loos-
en the drive chain, turn the adjust-
ing bolt on each side of the
swingarm in direction (b), and then
push the rear wheel forward.
EAU22940
6