Yamaha 20D Owner's Manual page 168

cC
Do not use the tilt support lever/knob
when trailering the boat. The outboard
motor could shake loose from the tilt
support and fall. If the motor can not be
trailered in the down position, use an
additional support device to secure it in
the up position.
EMU00327
Clamp handle mounting model
When transporting or storing the out-
board motor while removed from a boat,
fold the tiller handle and lean the motor
on the tiller handle to keep in a horizontal
position.
cC
Keep the power unit higher than the pro-
peller at all times. Otherwise, cooling
water can run into the cylinder, which
could result in damage.
NOTE:
Place a towel or the like under the out-
board motor to protect it from damage.
EMK17010
STORING OUTBOARD MOTOR
Procedure
1) Using fresh water, flush the cooling-
water passages (Refer to "Flushing
cooling system") and wash the motor
body. (Refer to "MOTOR EXTERIOR").
2) Remove the fuel-line connections
from the motor.
3) Run the engine at idling speed until
the carburetor is empty.
4-8
GB