Install Memory - PC Chips M755LMR User Manual

M755LMR Mainboard User's Manual
3. On the Socket-370, identify the Pin-1 corner. The Pin-1 corner
is at the end of the locking lever when it is locked.
4. Match the Pin-1 corners and insert the processor into the
socket. No force is required and the processor should drop into
place freely.
5. Swing the locking lever down and hook it under the catch on
the side of the socket. This secures the CPU in the socket.
6. All processors should be installed with a combination
heatsink/cooling fan, connect the cable from the fan to the
CPU fan power connector FAN1.

Install Memory

The mainboard has two DIMM sockets for system memory
modules. You must install at least one memory module in order to
use the mainboard. You must install the first memory module in
the DIMM1 socket to provide shared memory to the onboard
VGA display circuitry.
For this mainboard, you must use 168-pin, 3.3V unbuffered
SDRAM memory modules. If the installed CPU uses a 100 MHz
system bus, you must use PC100/PC133 memory. If the installed
CPU uses a 66 MHz system bus, you must use PC66/PC100
memory. You can install any size memory module from 16MB to
512MB, so the maximum memory size is 2 x 512MB = 1 GB.
The edge connectors on the memory modules have cut outs, which
coincide with spacers in the DIMM sockets so that memory
modules can only be installed in the correct orientation.
10
DIMM1
DIMM2