Weslo X LINE User Manual page 7

STEP 4
Take the Handlebar (9) and fix into place using Metal
Spacer (10) and Knob (11). Make sure you slide the
Hand Pulse Cable (4) over the Computer Bracket
through the hole on the back of handlebar post. Tighten
fully.
STEP 5
Remove three preassembled washers (13) and nylon
nuts (14) from back of the seat. Attach the Seat onto
Sliding Set (16) and secure them with three washers
(13) and three nylon nuts (14). Attach the seat with slid-
ing set onto Seat post (21), keep the bolt on the sliding
set outside.
Then secure the bolt with flat washer (19) and knob (20)
tightly.
STEP 6
Put the Seat Post (21) into Main Frame.
Select a suitable height setting and secure in place with
the Seat Support Adjuster Knob.
Note : Further more, you must ensure when setting
this desired position that the seat pillar is not pulled
out of the main frame further than the highest set-
ting position, which is marked.
STEP 7
Remove the 4 pre-fitted Screws (2) from the backside of
the Computer (1).
Connect the Upper Computer Cable (70) and two hand
pulse cable (4) with the cable on the back of computer
(1) separately, then secure the computer onto Handle-
bar Post Bracket using the 4 previously removed Screws
(2).
Attach the Handlebar Cover (3L+R) onto handlebar with
4 Screws (6).
Now, your machine is ready for use.
11
19
20
7
4
10 9
13
14
19
20
13
14
15
16
21
21
1
6
3L
70
2
15
16
21
3R
3L
1