Table of Contents
Advertisement
MOUNTING AND PAIRING THE REMOTE CONTROL SWITCH
How to mount
How to pair
Follow the steps below to pair the remote control switch with a light unit.
* The included remote control switch has been paired with the light unit at the
factory, so pairing is not necessary before use.
CAUTION!: • Do not look directly at the light when it is on.
1. Press and hold the switch on the light unit for 4 seconds. The switch will flash
Insulation
sheet
and await a signal (pairing mode) for 5 minutes.
* Keep pressing the switch even when the light turns on.
(WSW-001)
* To exit the pairing mode, press the switch on the light unit.
2. Pressing the remote control switch while the light unit is in pairing mode will
flash the light three times and complete the pairing. Press the remote control
switch to check that the light turns on.
Rubber band
• Perform pairing within 1 m from each other.
Press and hold
(4 seconds)
Pairing mode
Click
Flashing light
Pairing complete
Flashing
(5 minutes)
11
Advertisement
Table of Contents
