Download Print this page
Cateye HL-EL460RC Rear Manual
Cateye HL-EL460RC Rear Manual

Cateye HL-EL460RC Rear Manual

Rechargeable headlights

Advertisement

Quick Links

RECHARGEABLE HEADLIGHT
HL-EL460RC Rear
Manual
Before using the light, please read this manual and
the attached "Lithium-ion Batteries" thoroughly, and
keep them for future reference.
Design Pat. Pending
Copyright© 2013 CATEYE Co., Ltd.
EL460RC-Rear 130612 4
Light unit
Cartridge battery
RM-2 Bracket
USB cable
2
HOW TO MOUNT TO THE SADDLE
Mounted view
Range to mount
ø
6 – 8
mm
56 – 78
mm
CAUTION!
ENG
• Before your trip, please make sure the light is fi rmly mount-
ed to the bracket, it lights up, and the light is not blocked by
baggage, etc.
• Do not press the switch of the light while riding.
• Do not place it within children's reach.
• In preparation for unexpected battery shutoff, we recom-
mend you carry a spare cartridge battery and light.
• This product is water-resistant under normal daily use and
can be used in the rain. However, do not intentionally sub-
merge it in water.
1
HOW TO CHARGE
6 h
Standard
Approx.
charging time
(USB 2.0)
To PC or USB
battery charger
USB cable
2
1
Charge jack
cover
Saddle rail
Beam angle
adjustment
1
Bracket
Tightening torque: 1.5 – 2.0 N . m
Tightening torque
Release button
0.4 – 0.6 N . m
3
1. Connect the light unit to your PC or a
commercial USB battery charger using
Charging on the cradle
the USB cable. (Fig 1 1 - 2 )
The switch or the indicator on the
cradle lights up, and charging starts.
Cartridge battery
Indicator light: On Charging
Indicator light: Off Charging is completed
Cradle
* When your PC is in sleep state, the
unit cannot be charged.
* W e r e c o m m e n d u s i n g 5 0 0 + m A
(USB2.0) USB battery charger.
2. After charging is completed, remove
the USB cable, and install the charge
Indicator
jack cover.
1. Hold the saddle rail by the bracket and
tighten it with the screws. (Fig 2 1 )
4
CAUTION!: Do not tighten the screws
LOCK
5
2. Insert the light unit into the bracket
until it clicks, and adjust the beam
angle. ( 2 )
4
mm
To remove the light from the bracket,
pull it out backward while pressing
down on the release button. ( 3 )
3. After the angle adjustment, lock the
2
lever of the bracket and fi rmly tighten
the angle adjustment screw. ( 5 )
• If the light unit or parts become dirty with mud, etc., clean
with a soft cloth which is moistened with mild soap. Never
apply paint thinner, benzine or alcohol; damage will result.
• Dispose of used cartridge batteries appropriately according
to local regulations.
Before Initial Use
This unit is shipped with a small charge to check the light.
Be sure to charge it before use, according to the instructions
"HOW TO CHARGE".
* Charging and lighting times are ap-
proximate values, and will vary by
environmental and user conditions.
* The cartridge battery can be fast-
charged by using the optional charging
cradle (about 3 hours of charging time).
Use a 1A or higher USB charging
adapter when charging by the cradle.
CAUTION!:
• Check the screw of the bracket peri-
odically to make sure it is tightened
fi rmly.
too hard.
It may cause damage.
• Fix the bracket to saddle rail securely.
• Do not apply any excessive load or
impact to the bracket. It may cause
damage.

Advertisement

loading

Summary of Contents for Cateye HL-EL460RC Rear

  • Page 1 However, do not intentionally sub- “HOW TO CHARGE”. Design Pat. Pending merge it in water. Copyright© 2013 CATEYE Co., Ltd. EL460RC-Rear 130612 4 HOW TO CHARGE Light unit 1. Connect the light unit to your PC or a...
  • Page 2: Specifications

    2 years from original purchase. If the product Charge Micro USB plug fails to work during normal use, CatEye will repair or replace the defect at no Constant : Approx. 4 hours charge. Service must be performed by CatEye or an authorized retailer. To Flash : Approx.