Cateye VOLT 1700 Manual

RECHARGEABLE HEADLIGHT
HL-EL1020RC
Manual
Before using the light, read this
manual thoroughly and keep it for
future reference.
Design Pat. Pending
Copyright© 2018 CATEYE Co., Ltd.
EL1020RC-180221 2
WARNING!!!
• This light emits an extremely powerful beam equiva-
lent to automobile headlight so it may cause a hazard-
ous situation depending on the beam angle used.
Be sure to direct the light beam downward so the
driver approaching does not get dazzled.
• Before your trip, please make sure the light is firmly
mounted to the bracket and it lights up.
• Always attention to the remaining battery power by
checking the indicator periodically while using.
CAUTION!
• Do not stare at the light when it is illuminating.
Otherwise it may damage your eyesight.
• Do not place it within children's reach.
• In preparation for unexpected battery shutoff, we rec-
ommend you carry a spare cartridge battery and light.
• Mounting the light unit too close to a wireless comput-
er may adversely affect the reading of the computer.
• This product is water-resistant under normal daily use
and can be used in the rain. However, do not inten-
tionally submerge it in water.
• If the light unit or parts become dirty with mud, etc.,
clean with a soft cloth which is moistened with mild
soap. Never apply paint thinner, benzine or alcohol;
damage will result.
LITHIUM-ION BATTERIES
Cautions on recharging
• Avoid charging in direct sunlight or in a vehicle
parked under direct sunlight, and make sure to
charge only when the ambient temperature is
between 41°F and 104 °F (5 and 40°C).
• Before charging, be sure that no dust or other
foreign objects attach to the USB plug.
• Do not subject the light to vibrations while charging.
• Once charging is complete, be sure to disconnect
the USB plug.
Cautions in use
• Charging, discharging, and storing in high tem-
peratures will cause the rechargeable battery to
deteriorate faster. Do not place the light inside a
vehicle or near a heater.
• When the operating time decreases significantly,
the battery life is close to an end. Replace the
cartridge battery with a new one.
Cautions on storage
• Cool and dry storage is recommended. For long
period storage, it is important to charge the battery
30 minutes every 6 months.
• When you store the cartridge battery alone, be sure
to install the cap.
Otherwise, damage or a fire may be caused by
short circuit.
Cautions for dispose
Dispose of used cartridge batteries appropriately
according to local regulations.
ENG
Before Initial Use
This unit is shipped with a
small charge to check the
light. Be sure to charge it
before use, according to
the instructions "HOW TO
CHARGE".
1 HOW TO CHARGE
Standard charging time
Approx.
Charge jack cover
1
1. Connect the light unit to your PC or a commercial
USB battery charger using the USB cable.
1 2
( – )
The switch lights up, and charging starts.
Switch button light
Illuminated in red
Illuminated in orange Charging (more than 50% )
Illuminated in green Charging is completed
* When your PC is in sleep state, the unit cannot
be charged.
* Use a USB battery charger of 500mAh (USB2.0)
or more. The cartridge can be fast-charged with
high capacity USB battery charger.
2 HOW TO MOUNT TO A BICYCLE
Bracket
1
Strap
1. Mount the bracket to the handlebar. (
2. Insert the light unit into the bracket until it clicks,
and adjust the beam angle. (
Beam angle adjustment
Turn on the light on a smooth road at night,
and loosen the dial slightly to move the bracket.
Adjust the beam angle so it does not direct to
a driver approaching and then tighten the dial
firmly to fix the bracket.
Light unit
Cartridge battery
(BA-6.8TF)
5.5 – 15 h
State (charging rate)
Charging (less than 50%)
Rubber pad Dial
2
3
1 – 3 )
4
)
NO!
OK
USB cable
(MICRO USB)
USB cable
To PC or USB battery
charger
2
2. After charging is completed, remove the USB cable,
and install the charge jack cover.
* The battery charges to about 80% after approxi-
mately 12 hours.
* Charging time is approximate values, and will vary
depending on the environmental and usage condi-
tions.
*1
Screw
4
3. To remove the light unit, pull out it forward while
pressing down on the release button (
CAUTION!:
• Be sure to tighten the dial by hand. When you
tighten it too hard with a tool, the screw thread
may be stripped.
• Check the dial and screw (*1) on the bracket pe-
riodically, and use them without any loosening.
• Round off the cut edge of the bracket strap to
prevent injury.
FlexTight™ bracket
(H-34N)
5
Release button
5
).