Cateye AMPP 400 Manual

RECHARGEABLE HEADLIGHT
HL-EL084RC
Manual
Before using the light, read this manual
thoroughly and keep it for future
reference.
Design Pat. Pending
Copyright© 2019 CATEYE Co., Ltd.
1
HLEL084RC-190603
Light unit FlexTight™ bracket
( H-34N )
USB cable
( MICRO USB )
Before Initial Use
This unit is shipped with small charge to check the
light. Be sure to charge it before use, according to
the instructions "HOW TO CHARGE" and
"Cautions on recharging".
WARNING!!!
• Be sure to direct the light beam downward so
approaching car or pedestrian are not dazzled.
• Before your trip, please make sure the light is firmly
mounted to the bracket and it lights up.
• Always pay attention to the remaining battery power
by checking the indicator periodically while using the
light.
CAUTION!
• Keep the light away from children.
• Mounting the light unit too close to a wireless computer
may adversely affect the reading of the computer.
• In preparation for unexpected shutoff, we recommend
you carry a spare light.
• This product is water-resistant under normal daily
use and can be used in the rain. However, do not
intentionally submerge it in water.
• If the light unit or parts become dirty with mud, etc.,
clean with a soft cloth which is moistened with mild
soap. Never apply paint thinner, benzine or alcohol;
damage will result.
LITHIUM-ION BATTERIES
Cautions on recharging
• Avoid charging in direct sunlight or in a vehicle parked
under direct sunlight, and make sure to charge only
when the ambient temperature is between 41°F and
104 °F (5 and 40°C).
• Before charging, be sure that no dust or other foreign
objects are attached to the USB plug.
• Do not subject the light to vibrations while charging.
• Once charging is complete, be sure to disconnect the
USB plug.
Cautions in use
• Charging, discharging, and storing in high
temperatures will cause the rechargeable battery to
deteriorate faster.
Do not place the light inside a vehicle or near a heater.
• If the illumination time is significantly reduced even
after proper charging, the rechargeable battery may
be nearing the end of its service life. Dispose of the
battery as described in "Cautions for disposal".
Cautions on storage
Cool and dry storage is recommended. For long period
storage, it is important to charge the battery 30 minutes
every 6 months.
Cautions for dispose
When disposing of the light unit, dispose of it
according to local regulations.
1
ENG
HOW TO CHARGE
1
Charge jack cover
1. Connect the light unit to your PC or a commercial USB battery charger using the USB cable. (Fig.1
The indicator turns red and charging starts.
* When your PC is in sleep state, the unit cannot be charged.
* Use a USB battery charger of 500 mAh (USB2.0) or more.
2. Once charging is complete, disconnect the USB cable and securely attach the charge jack cover.
CAUTION!: Attach the charge jack cover securely to ensure waterproofness.
* Charging and lighting times are approximate values, and will vary by environmental and use conditions.
2
HOW TO MOUNT TO A BICYCLE
Bracket
1
Rubber pad
Strap
4
*1
NO!
OK
CAUTION!:
• Be sure to tighten the dial by hand. If tightened too hard with a tool, the screw thread may be stripped.
• Check the dial and screw (*2) on the bracket periodically, to monitor for any loosening.
• If cutting the strap, be careful of injury from where the strap is cut. (*3)
3
SWITCH OPERATION
OFF
Press
Double-click
and hold
High
Click
*4 When turning the light on, it lights up in the mode that was used last time. (Mode memory function)
Remaining battery capacity :
When the switch is illuminated in red, there is little remaining
battery power. Please charge as soon as possible.
2
USB cable
To PC or USB battery charger
3
Dial
2
*3
2
4
Release
Screw
*2
button
Switch (Indicator)
ON
Press and hold
*4
High
Double-click
Flashing
*4
Indicator
Steady
red light
Off
Standard charging time
4
Approx. (1A)
1. Mount the bracket to the
handlebar. (Fig.2
3
2. Insert the light unit into the
bracket until it clicks, and
adjust the beam angle. ( )
(*1)
3. To remove the light unit, pull it
forward while pressing down
on the release button ( ,
* To readjust the beam angle,
6
loosen the dial and/or the
screw enough to move the
bracket, and firmly tighten
them after adjustment. (*2)
5
Click
Daytime
HyperConstant
Switch
(Indicator)
Charging
Charging is
completed
- 8
h
(0.5A)
– ).
1 2
– )
1 3
4
).
5 6
Low