Areas Of Application; Fitting/Removing Attachments - Silvercrest SDR 1100 A2 Operating Instructions Manual

Areas of application

You can clean either by using steam directly from the steam nozzle
can fit an accessory.
■ Do not use an accessory if you want to clean items such as toilets and sinks,
taps and drains, windows, furniture, fabrics, shutters or mirrors.
You can easily remove water and dissolved dirt from smooth surfaces after
cleaning using the squeegee attachment
NOTE
► The closer you hold the steam nozzle
better the effect. The steam pressure and temperature are at their highest
directly after leaving to the steam nozzle
► Stubborn stains and dirt must be soaked with water beforehand.
■ Use the angle nozzle
■ Use the round brush

Fitting/removing attachments

WARNING! RISK OF INJURY!
► Always remove the plug from the mains power socket before you fit/remove
an attachment.
► Wait until the appliance has cooled down before you fit/remove an attach-
ment.
► Wait until all of the steam has dissipated before you fit/remove an attach-
ment.
Extension hose
Push the extension hose
The marking line on the extension hose
line on the appliance must be aligned with each other
(see fold-out page Figure A).
Turn anticlockwise until both marking lines on the extension hose
aligned with both marking lines on the appliance. The extension hose
remains locked in this position (see fold-out page Figure B).
NOTE
► The fixture on the appliance has a joint so that the attachment can be
aligned to the best usage position. This is, however, not possible with the
extension hose
■ The extension hose
SDR 1100 A2
6
for tight corners or joints, or hard-to-reach places.
12
for stubborn soiling, for example, on wheel rims.
11
on to the steam nozzle
9
.
9
is removed in the reverse order.
9
6
.
13
to the surface to be cleaned, the
.
6
as far as the stop.
6
and the marking
9
or you
GB
are
9
9
43