Supporting The Motorcycle - Yamaha WR250R Owner's Manual

Periodic maintenance and adjustment
1
2
3
1
4
5
1. License plate light unit
2. License plate light bulb socket
6
3. Remove the burnt-out bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
7
5. Install the socket (together with the
bulb) by pushing it in.
8
6. Install the license plate light unit by
installing the screws.
9
10
11
12

Supporting the motorcycle

Since this model is not equipped with a
2
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
EAU24351 frame in front of the rear wheel or under
each side of the swingarm.
6-38