Clutch Lever - Yamaha XVS950CR Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
3
Press this switch to sound the horn.
Start/Engine stop switch " /
To crank the engine with the starter,
set this switch to "
the " " side of the switch. See page
5-1 for starting instructions prior to
starting the engine.
Set this switch to "
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
The engine trouble warning light will
come on when the key is turned to
"ON" and the start switch is pushed,
but this does not indicate a malfunc-
tion.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
EAU12501
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
EAU54211 when your vehicle is stopped where it
/ "
might be a traffic hazard.
", and then push
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
" to stop the en-
tery may discharge.
"SELECT" switch
This switch is used to perform selec-
EAU41701
tions in the odometer and tripmeters
and to set the clock of the multi-func-
tion meter unit.
See "Multi-function meter unit" on
page 3-5 for detailed information.
EAU12735

Clutch lever

" posi-
ECA10062
1. Clutch lever
The clutch lever is located at the left
handlebar grip. To disengage the
clutch, pull the lever toward the han-
dlebar grip. To engage the clutch, re-
lease the lever. The lever should be
EAU55701
pulled rapidly and released slowly for
smooth clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
tion circuit cut-off system. (See page
3-18.)
3-9
EAU12821
1