Yamaha XVS950CR Owner's Manual page 22

INSTRUMENT AND CONTROL FUNCTIONS
To set the clock
3
1. Clock
1. Push the "SELECT" switch for at
least 5 seconds.
2. When the hour digits start flash-
ing, push the "SELECT" switch to
set the hours.
3. Push the "SELECT" switch for at
least one second, and the minute
digits will start flashing.
4. Push the "SELECT" switch to set
the minutes.
5. Push the "SELECT" switch for at
least one second to start the
clock.
Self-diagnosis device
1
1. Error code display
2. Engine trouble warning light "
3. Immobilizer system indicator light "
This model is equipped with a self-di-
agnosis device for various electrical
circuits.
If a problem is detected in any of those
circuits, the engine trouble warning
light will come on and the display will
indicate an error code.
If the display indicates any error codes,
note the code number, and then have
a Yamaha dealer check the vehicle.
The self-diagnosis device also detects
problems in the immobilizer system
circuits.
If a problem is detected in the immobi-
lizer system circuits, the immobilizer
system indicator light will flash and the
display will indicate an error code.
TIP
1
If the display indicates error code 52,
this could be caused by transponder
2
interference. If this error code appears,
try the following.
3
1. Use the code re-registering key to
"
"
TIP
Make sure there are no other immobi-
lizer keys close to the main switch, and
do not keep more than one immobilizer
key on the same key ring! Immobilizer
system keys may cause signal interfer-
ence, which may prevent the engine
from starting.
2. If the engine starts, turn it off and
3. If one or both of the standard keys
3-7
start the engine.
try starting the engine with the
standard keys.
do not start the engine, take the
vehicle, the code re-registering