Changing The Brake Fluid - Yamaha XCITY VP250 Owner's Manual

Before riding, check that the brake fluid
is above the minimum level mark and
replenish if necessary. A low brake fluid
level may indicate worn brake pads
and/or brake system leakage. If the
brake fluid level is low, be sure to check
the brake pads for wear and the brake
system for leakage.
Observe these precautions:
G When checking the fluid level,
make sure that the top of the brake
fluid reservoir is level.
G
Use only the recommended quality
brake fluid, otherwise the rubber
seals may deteriorate, causing
leakage and poor braking perfor-
mance.
Recommended brake fluid:
DOT 4
G
Refill with the same type of brake
fluid. Mixing fluids may result in a
harmful chemical reaction and
lead to poor braking performance.
PERIODIC MAINTENANCE AND ADJUSTMENT
G
Be careful that water does not en-
ter the brake fluid reservoir when
refilling. Water will significantly
lower the boiling point of the fluid
and may result in vapor lock.
G
Brake fluid may deteriorate paint-
ed surfaces or plastic parts. Al-
ways clean up spilled
immediately.
G As the brake pads wear, it is nor-
mal for the brake fluid level to grad-
ually go down. However, if the
brake fluid level goes down sud-
denly, have a Yamaha dealer
check the cause.
6-18

Changing the brake fluid

Have a Yamaha dealer change the
brake fluid at the intervals specified in
the TIP after the periodic maintenance
and lubrication chart. In addition, have
the oil seals of the brake master cylin-
der and caliper as well as the brake
fluid
hose replaced at the intervals listed be-
low or whenever they are damaged or
leaking.
G Oil seals: Replace every two
years.
G
Brake hose: Replace every four
years.
EAU22721
6