Yamaha XCITY VP250 Owner's Manual page 22

INSTRUMENT AND CONTROL FUNCTIONS
3
ZAUM0394
3. Push the "MODE" button, and the
minute digits will start flashing.
4. Push the "SET" button to set the
minutes.
5. Push the "MODE" button and then
release it to start the clock. The
display will return to the "Total"
mode.
ZAUM0395
Ambient temperature display
1
2
3
ZAUM0396
1. Frost warning indicator " "
2. Minus item
3. Temperature
This display shows the ambient tem-
perature from –30 °C (–86 °F) to 50 °C
(122 °F).
The frost warning indicator " " auto-
matically comes on if the temperature is
lower than 3 °C (37 °F).
3-5
Oil change indicator "OIL"
1
ZAUM0582
1. Oil change indicator "OIL"
The engine oil should be changed
when this indicator comes on. The indi-
cator stays on until it is reset. After
changing the engine oil, reset the indi-
cator as follows.
1. While holding the "MODE" and
"SET" buttons pushed, turn the key
to " ".
2. Continue holding the "MODE" and
"SET" buttons pushed for two to
five seconds.
3. Release the buttons and the oil
change indicator will go off.