Yamaha TDM900 Owner's Manual page 53

then lift the fuel tank to position it
away from the coolant reservoir.
(Do not disconnect the fuel hoses!)
5. Place a container under the engine
to collect the used coolant.
6. Remove the radiator cap retaining
bolt and the radiator cap.
WARNING
Never attempt to remove the radiator
cap when the engine is hot.
1. Radiator cap retaining bolt
2. Radiator cap
7. Remove the coolant drain bolts to
drain the cooling system.
PERIODIC MAINTENANCE AND MINOR REPAIR
EWA10380
1
1. Coolant drain bolt
8. Remove the coolant reservoir bolt.
1
2
1. Bolt
2. Coolant reservoir
9. Pull the coolant reservoir upward
and away from the vehicle.
10. Drain the remaining coolant from
the coolant reservoir by opening
1
1 2
6-12
the cap, then turning the reservoir
upside down.
11. Install the coolant reservoir by
placing it in the original position,
then installing the bolt.
12. After the coolant is completely
drained, thoroughly flush the cool-
ing system with clean tap water.
13. Install the coolant drain bolts, and
then tighten them to the specified
torque.
NOTE:
Check the washers for damage and re-
place them if necessary.
Tightening torque:
Coolant drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
14. Pour the recommended coolant
into the radiator until it is full.
2
3
4
5
6
7
8
9