Temperature Range; Temperature Display - Miele KWT 6322 UG Operating And Installation Instructions

 Touch the OK sensor to confirm your
selection
or
 wait approximately 5 seconds after
the last touch of a sensor.
The temperature being set will flash in
the display.
The following information shows in the
display while the sensors are being
touched:
– Touching a sensor once: the last
temperature selected flashes.
– Each subsequent touch of the
sensor: adjusts the temperature
shown in 1 °C steps.
– Leaving a finger on the sensor
changes the temperature continu-
ously.
A tone will sound (if the sensor tone
is switched on) when the lowest or
highest possible temperature is
reached.
Approximately 5 seconds after the last
time a sensor has been touched, the
actual temperature inside the appliance
is automatically shown.
When the temperature is altered, there
is a short delay until the temperature
selected is set.
The temperature display on the control
panel always shows the actual tem-
perature.
The optimum temperature and air quality

Temperature range

In both zones it is possible to set tem-
peratures between 5 and 20 °C.

Temperature display

In normal operation the temperature
display shows the actual temperature in
the zone.
If the temperature in one of the zones is
not within the range that the appliance
is able to display, dashes will light up in
the temperature display.
Depending on the ambient temperature
and the temperature setting, it can take
the appliance a few hours to reach the
temperature required and for this tem-
perature to then be shown as a con-
stant temperature in the display.
27