Clutch Lever - Yamaha XSR MTM690 Owner's Manual

Instrument and control functions
Pass switch " "
Press this switch to flash the headlight.
Dimmer switch " /
Set this switch to "
3
beam and to " " for the low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to " ". To signal a left-hand
turn, push this switch to "
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch " "
Press this switch to sound the horn.
Stop/Run/Start switch "
To crank the engine with the starter,
set this switch to "
the switch down towards " ". See
page 5-1 for starting instructions prior
to starting the engine.
Set this switch to "
EAU12351
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
EAU12401
"
" for the high
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
EAU12461
/ " ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
". When emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
EAU12501
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU54212
/ / "
", and then push
" to stop the en-

Clutch lever

EAU12735
" posi-
1. Clutch lever
The clutch lever is located on the left
side of the handlebar. To disengage
ECA10062 the clutch, pull the lever toward the
handlebar grip. To engage the clutch,
release the lever. The lever should be
pulled rapidly and released slowly for
smooth clutch operation.
The clutch lever is equipped with a
clutch switch, which is part of the igni-
tion circuit cut-off system. (See page
3-22.)
3-13
EAU12822
1