Cleaning The Air Filter Element - Yamaha XJR1300 Owner's Manual

Tightening torque:
Oil filter element drain screw:
7.0 Nm (0.7 m·kgf, 5 ft·lbf)
10. Install the panel.
11. Install the engine oil drain bolt, and
then tighten it to the specified
torque.
Tightening torque:
Engine oil drain bolt:
43 Nm (4.3 m·kgf, 31 ft·lbf)
12. Add the specified amount of the
recommended engine oil, and then
install and tighten the oil filler cap.
Recommended engine oil:
See page 8-1.
Oil quantity:
Without oil filter element replace-
ment:
3.00 L (3.17 US qt) (2.64 Imp.qt)
With oil filter element replacement:
3.35 L (3.54 US qt) (2.95 Imp.qt)
CAUTION:
G In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
PERIODIC MAINTENANCE AND MINOR REPAIR
mix any chemical additives. Do
not use oils with a diesel speci-
fication of "CD" or oils of a high-
er quality than specified. In
addition, do not use oils labeled
"ENERGY CONSERVING II" or
higher.
G
Make sure that no foreign mate-
rial enters the crankcase.
13. Start the engine, and then let it idle
for several minutes while checking
it for oil leakage. If oil is leaking, im-
mediately turn the engine off and
check for the cause.
NOTE:
After the engine is started, the engine
oil level warning light should go off if the
oil level is sufficient.
CAUTION:
If the oil level warning light flickers
or remains on, immediately turn the
engine off and have a Yamaha dealer
ECA11620
check the vehicle.
14. Turn the engine off, and then
check the oil level and correct it if
necessary.

Cleaning the air filter element

The air filter element should be cleaned
at the intervals specified in the periodic
maintenance and lubrication chart.
Clean the air filter element more fre-
quently if you are riding in unusually
wet or dusty areas.
1. Remove the seat. (See page
2. Remove panel A. (See page 6-5.)
3. Remove the air filter case cover by
ECA10400
1. Air filter case cover
2. Screw
4. Pull the air filter element out.
6-10
3-14.)
removing the screws.
EAU20610
6