BMW S 1000XR Rider's Manual page 140

8
138
Tighten axle clamping screws 1
to appropriate torque.
z
Clamping screw in axle
adapter
Tightening sequence: Tighten
the screws 6 times, alternating
between one and the other
each time
14 lb/ft (19 Nm)
Remove front wheel stand.
Slide the brake calipers on the
left-hand and right-had side
onto the brake rotors.
Install securing screws 4 on left
and right with specified torque.
Radial brake calipers on
the axle adapter
28 lb/ft (38 Nm)
Remove adhesive tape from
wheel rim.
WARNING
Brake pads do not contact
the brake disk.
Delayed braking action.
Before driving off, check that
the braking effect kicks in with-
out any delay.