Calibrate By Inputting Parameter; Conducting Exercise - Oregon Scientific SE833 User Manual

CALIBRATE BY INPUTTING PARAMETER

You can only know your parameter if you have already
successfully calibrated by running or walking beforehand.
This is because the parameter is the same value displayed
after you have successfully calibrated by running or walking.
By inputting parameter, you will be spared the time of
calibrating by running or walking again.
1. Press MODE repeatedly to select
2. Press SET.
3. Press ST/LAP/+ repeatedly to select "CAL DEVICE".
4. Press SET.
5. Press ST/LAP/+ to select "PARA INPUT".
6. Press SET to confirm selection.
7. Input parameter for Walk by pressing ST/LAP/+ to
increase values or - / SP to decrease values. The
parameter is the same value after you have successfully
calibrated by walking.
8. Press SET to confirm.
9. Input parameter for Run by pressing ST/LAP/+ to
increase values or - / SP to decrease values. The
parameter is the same value after you have successfully
calibrated by running.
10. Press SET to confirm.

CONDUCTING EXERCISE

IMPORTANT To ensure accurate calculations with your
exercise, you should pair the watch with SZ909 chest belt or
other devices such as bike pod. However, if without pairing,
the chest belt will only receive heart rate signal.
SE833 EN 11.indd 12
There are 2 options for exercise: AUTO and PROG.
AUTO refers to conducting exercise without using the
•
set exercise profile.
PROG refers to conducting exercise by using the set
•
exercise profile (refer to "SET EXERCISE PROFILE"
section in this manual).
To conduct exercise:
.
1. Press MODE to select
To exercise without exercise profile, select
•
• To exercise with exercise profile, press ST/LAP/+ to
select
Press SET, then press -/SP or ST/LAP/+ to select
which exercise profile to use.
12
.
available lap
memory
available lap
memory
6/1/09 10:07:25 AM