Adjusting The Motion-Control Levers; Pushing The Machine By Hand - Toro 74855 Operator's Manual

Adjusting the Motion-Control
Levers
Adjusting the Height
Note: Repeat the adjustment for the opposite control lever.
The motion-control levers can be adjusted higher or lower for
maximum operator comfort
A
g027252
Figure 26
(Figure 26).
B
Adjusting the Tilt
The motion-control levers can be tilted forward or rearward
for maximum operator comfort.
1. Loosen the upper bolt holding the control lever to the
control-arm shaft.
2. Loosen the lower bolt just enough to pivot the control
lever forward or rearward.
3. Tighten both bolts to secure the control in the new
position.
4. Repeat the adjustment for the opposite control lever.

Pushing the Machine by Hand

Important: Always push the machine by hand. Never
tow the machine because damage may occur.
1. Park the machine on a level surface and disengage the
blade control switch.
2. Move the motion control levers outward to neutral
lock position, shut off the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position. Make sure that the parking brake
is disengaged.
3. Do this procedure on each side of the machine
27).
A
C
4. Move the bypass to the position for operating the
machine (Figure
24
B
D
Figure 27
27) to engage the wheel motors.
(Figure
g027642