Toro 74855 Operator's Manual page 46

1
4
3
5
Figure 67
1. Deflector
2. Deck brackets
3. Rod
3. Position the new discharge deflector with the bracket
ends between the welded brackets on the deck
67).
4. Install the spring onto the straight end of the rod.
Note: Position the spring on the rod as shown in so
the shorter spring end is coming from under the rod
before the bend and going over the rod as it returns
from the bend.
5. Lift the loop end of the spring and place it into the
notch on the deflector bracket
2
g024317
4. Spring
5. Spring installed over the
rod
6. Cotter pin
(Figure
(Figure 68).
2
3
4
1. Rod and spring assembly
partially installed
2. Loop end of the spring
installed into the notch in
the deflector bracket
6. Secure the rod and spring assembly by twisting it so the
short end of the rod can be placed behind the front
bracket welded to the deck
Important: The grass deflector must be spring
loaded in the down position. Lift the deflector up
to test that it snaps to the full down position.
7. Install the cotter pin into the end of the rod
46
1
G024316
Figure 68
3. Rod, short end, moved
behind the mower bracket
4. Short end, retained by the
mower bracket
(Figure 68).
(Figure 67).