Battery Replacement And Disposal - Extreme Networks Summit X150 Series Installation Manual

plugging the AC supply power cord into a power supply.
For specific product input power requirements refer to the data sheet of the product or modular power supply at
http://www.extremenetworks.com or to
The following countries have specific safety instructions concerning power connectors:
Argentina: The supply plug must comply with Argentinean standards.
●
Australia: Use AS 3112 for 110/220 VAC power supplies.
●
Denmark: The supply plug must comply with section 107-2-D1, standard DK2-1a or DK2-5a.
●
International: Use CEE 7/7 for 110/220 VAC power supplies.
●
Japan:
●
Use JIS 8303 for 110/220 VAC power supplies.
●
The power cord provided with the power supply, switch, or chassis is for use only with that
●
specific product from Extreme Networks; it is not for use with any other product from Extreme
Networks or any other vendors' equipment.
North America: The cord set must be cULus listed or cCSAus listed.
●
Switzerland: The supply plug must comply with SEV/ASE 1011.
●
United Kingdom: Use BS 1363 for 110/220 VAC power supplies.
●
NOTE
This equipment is not intended to be directly powered by power distribution systems where phase-phase voltages
exceed 240V AC (2P+PE), such as those used in Norway, France, and other countries. For these applications it is
recommended that a transformer be used to step down the voltage to < 240V AC from phase-phase, or that you
make a connection to a (P+N+PE) power distribution where voltages do not exceed 240V AC.
All installations should confirm that the product is reliably grounded according to the country's local electrical
codes.
NOTE
Building codes vary worldwide; therefore, Extreme Networks strongly recommends that you consult an electrical
contractor to ensure proper equipment grounding and power distribution for your specific installation & country.

Battery Replacement and Disposal

Batteries included with Extreme products are encapsulated and must be replaced by qualified Extreme
Service personnel only. Contact your Extreme Service personnel for product replacement. Do not
attempt to replace the battery. If these instructions are disregarded and replacement of these batteries is
attempted, the following guidelines must be followed to avoid danger of explosion:
Replace with the same or equivalent battery type as recommended by the battery manufacturer.
●
Dispose of the battery in accordance with the battery manufacturer's recommendation.
●
ExtremeXOS Summit Family Switches Hardware Installation Guide
Appendix B of this guide.
167