Extreme Networks Summit X150 Series Installation Manual page 159

a Remove the retaining screws at the top corners of the module, and set the screws aside in a safe
place.
Save the retaining screws to secure the new module in the switch.
b Rotate the inserter/extractor levers downward to disconnect the internal module connectors.
c Carefully slide the module out of the switch and set it on an anti-static surface.
Figure 126: Removing a VIM1 Module (VIM1-SummitStack Module Shown)
4 Remove the replacement VIM1module from its anti-static packaging.
5 Install the replacement VIM1 module in the switch
a Make sure the inserter/ejector levers are rotated down.
b Carefully slide the module into the switch until the inserter/ejector levers begin to rotate upward.
c Simultaneously rotate both levers upward to seat the module internal connectors.
d Insert and tighten the retaining screws you removed earlier.
Figure 127: Installing a VIM1 Module
ExtremeXOS Summit Family Switches Hardware Installation Guide
SH_092
(Figure 127):
SH_093
159