Table of Contents
Advertisement
7
CONTROLLING
The projector can be controlled with
a. the RCU
b. the hardwired RCU (cable is not included)
c. the local keypad.
Controlling the projector with the RCU and the hardwired RCU is
equal.
How to use the RCU?
a) Point the front of the RCU to the reflective screen surface.
Ceiling
Screen
b) RCU used in a hardwired configuration.
1 00 - 2 3 0 V
T hi s devi ce co mpl i es wi t h P art 15 of t he F CC rul es.
Operat i on
I
i s s ubj ect t o f ol l owi ng t wo co ndi t i o ns :
0
9
- 4 A
(1 ) T h i s d evi c e m ay n ot c ause har mf u l i n t erf eren ce
(2 ) T h i s devi ce must ac cept an y i nt er f er ence re cei v ed
60 - 5 0 H z
i n cl ud i ng i nt er f er ence t h at m ay cau se u nde si re d o per at i o n
DIAGNO STICS
CODE
IR-ACKNO WLEDGED
IR-RECEIVER
RS2 32 O UT
IR-RECEIVED
Plug one end of the remote cable in the connector on the bottom of
the RCU and the second side in the connector in the front panel of the
projector labelled 'REMOTE'.
5975207 BARCOGRAPHICS 9100 081196
IR sensor
RCU
c) Point the front of the RCU directly at one of the IR sensors of the
projector.
IR sensor
Ceiling
Front of projector
0
RCU
9
7
8
5
6
3
4
1
2
When using the wireless remote control, make sure you are within the
effective operating distance (30m, 100ft in a straight line). The
remote control unit will not function properly if strong light strikes the
sensor window or if there are obstacles between the remote control
unit and the projector IR sensor.
Projector address
a. Software set up of the projector address.
See 'Change projector address' in chapter 'Service mode'.
b. How to control the projector or projectors.
Every projector requires an individual address between 0 and 255
which can be set in the Service mode.
When the address is set, the projector can be controlled now :
- RCU for addresses between 0 and 9.
- computer, e.g. IBM PC (or compatible), Apple MAC, etc. for
addresses between 0 and 255.
Note : a projector will respond to a RCU set to an address of '0'
regardless of what address is set in the projector itself.
c. Using the RCU.
Before using the RCU, its is necessary to enter the projector address
into the RCU (only when that address is between 0 and 9). The
projector with the corresponding address will listen to that specific
RCU.
When address 0, 'zero address' is programmed into the RCU, every
projector, without exception will listen to the commands given by this
RCU.
Controlling
Table
Rear of projector
IR sensor
0
RCU
9
7
8
5
6
3
4
1
2
7 - 1
Advertisement
Table of Contents
