Table of Contents
Advertisement
6.2
Electronic shutter specification
Exposure time
MANUAL
Exposure time Accuracy
6.3
Random Trigger Shutter specification
Trigger Mode
External trigger
Software trigger
Exposure time
Edge mode
Level mode
Bulk mode
Number of Exposures in Bulk mode
Sequential Shutter
Trigger Delay
AntiGlitch
AntiChattering
6.4
GPIO Input signal specification
I/O Connector Pin No,
Input circuit
Input level
Polarity
Pulse width
Input impedance
Copyright © 2016 TOSHIBA TELI CORPORATION, All rights reserved.
3μs (in overlap exposure operation)
External trigger, Software trigger (factory setting : External trigger)
USB3 Vision command control
Edge mode, Level mode, Bulk mode (factory setting : Edge mode)
The exposure time depends on the MANUAL Exposure time setting
The exposure time depends on External trigger width
The exposure time depends on the MANUAL Exposure time setting
0 to 2000000μs (factory setting : 0μs)
90ns to 2ms (factory setting : 90ns)
2μs to 2ms (factory setting : 2μs)
10kΩ
Low: 0 to 0.5V, High: 2.0 to 24.0V
High active / Low active (factory setting : Low active)
19
MANUAL
30μs to 16s
Input via I/O connector
255 times (maximum)
16 entries (maximum)
4 Pin : Line0
Inside
DC3.3V
4
3
50μs (minimum)
High impedance
http://www.toshiba-teli.co.jp/en/index.htm
0V
D4253375C
Advertisement
Table of Contents
