Figure 3-1: Enter Network Password Screen - AudioCodes Mediant 2000 User Manual

"
"
$ For a quick Mediant 2000 setup, take the next 12 steps:
1. Power-up the Gateway. After self-testing, in about 20 seconds the ACT LED on front
panel turns to green. Any malfunction causes the Fail LED to turn to red.
2. Before using your Web browser to access the Embedded Web Server, change your
PC's IP address and Subnet Mask to correspond with the Gateway's factory default IP
address and Subnet Mask.
3. Open any standard Web-browsing application such as Microsoft™ Internet Explorer™
(Ver. 5.0 and higher) or Netscape™ Navigator™ (Ver. 7.0 and higher) and specify the
IP address of the Media Gateway in the 'Address' field (e.g., http://10.1.10.10 for the
first module); the Embedded Web Server 'Enter Network Password' screen appears,
Figure 3-1.
4. Enter the User Name and Password (default: Admin, Admin). Note that the User Name
and Password fields are case-sensitive. Click OK; the 'Quick Setup' screen is accessed.
5. In the 'Quick Setup' screen set the Gateway's new IP address, NAT IP Address, Subnet
Mask and Default Gateway IP Address.
6. Set the basic SIP Gateway Parameters, shown in Figure 3-2 below.
Mediant 2000/SIP
Subnet: 255.255.0.0,
Default Gateway: 0.0.0.0

Figure 3-1: Enter Network Password Screen

30
Mediant 2000/SIP
Document #: LTRT-00688