Safety Guidelines; Safe Handling; Safety; Power Supply - Seagate SRPS20 User Manual

Safety Guidelines

Important info: Refer to

is not described in this manual.

Safe handling

The Seagate WSS NAS 2-Bay | 4-Bay | 6-Bay must run with all of its parts and units in place. In order to
comply with applicable safety, emission, and thermal requirements, the cover should not be removed and
all drives and/or empty drive trays must be installed according to the instructions (see Setup).
Permanently unplug the unit if you think that it has become damaged in any way.
With the sole exception of "hot-swapping" compatible hard drives from protected volumes (see
Maintenance), you must shut down and disconnect power from the NAS before maintenance or physical
troubleshooting is performed on the device. Only qualified technical service personnel should be allowed to
maintain the NAS.
Shut down and unplug the unit before moving it.

Safety

Power supply

The Seagate WSS NAS must only be operated from a power supply input voltage range of 100 - 240 VAC, 50
to 60 Hz.
Make sure that the socket outlets are located near the equipment and are easily accessible.
The power supply on this unit is not serviceable or field replaceable. If Seagate technical support determines
that the power supply is faulty or has failed and the unit is under warranty, return the NAS to Seagate per the
instructions provided by the Seagate technician.
Ba ery
The battery in the Seagate WSS NAS is not field-replaceable. If Seagate technical support determines that
the battery is faulty or has failed and the unit is under warranty, return the NAS to Seagate per the
instructions provided by the Seagate technician. If you attempt to remove or replace the battery:
There is a strong risk of explosion when using an incorrect type.
You will void the device warranty.
Seagate WSS NAS 2-Bay | 4-Bay | 6-Bay
Warranty before performing any hardware repairs or maintenance that
4/13/15
Hard Drive
9