Table of Contents
Advertisement
IP REMOTE CONTROL INSTALLATION & OPERATION
Two-function wireless remote control system for On/Off-Hi/
Lo operation of the AF-4000 gas control valve
FCC REQUIREMENTS
NOTICE: The manufacturer is not responsible for any radio
or TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user's
authority to operate the equipment.
INTRODUCTION
This remote control system was developed to provide a safe,
reliable, and user-friendly remote control system for use with
the AF-4000 gas control valve used with some gas heating
appliances. The system operates on radio frequencies (RF)
within a 20-foot range using non-directional signals. The system
operates on one of 255 factory-programmed security codes; the
remote receiver must learn the transmitter code prior to initial
use.
TRANSMITTER
This remote control Transmitter allows the user to turn the
fireplace on and off, and adjust the flame height.
The transmitter operates with a 12V battery (included).
Before using the transmitter, install the battery in the battery
compartment.
For long life and optimal performance, replace the transmitter
battery annually with a 12V alkaline battery only.
Under normal use, an alkaline battery can last up to 12 months.
Frequent use of the Hi/Lo buttons may reduce battery life. The
transmitter should operate with as little as 9.0 volts battery power.
33858-1-0615
The transmitter has ON/OFF and HI/LO functions. When you
press a button on the transmitter, the signal light illuminates to
verify that a signal is being sent.
Upon initial use, there may be a delay of three seconds before
the remote receiver responds. This is part of the system's design.
If the signal light does not illuminate, check the position of the
transmitter's battery.
MATCHING SECURITY CODES
Each transmitter can use one of 255 security codes. You may
need to program the module to match the transmitter security
code upon initial use, or after replacing batteries, or if you need
to replace the transmitter.
Slide button on the module to the REMOTE position;
Press and release the LEARN button on the module to accept
the transmitter security code and then press any button on the
transmitter.
A change in the module's beeping pattern indicates the
transmitter's code has been accepted. Once the module has
accepted the new transmitter code, the new security code will
replace the old one.
The microprocessor that controls the security code matching
procedure is controlled by a timing function. If you are
unsuccessful in matching the security code on the first
attempt, wait two minutes before trying again - this allows the
microprocessor to reset its timer circuitry. If you are unable to
match the code after three tries, contact your dealer..
OPERATION
1.
This remote control will operate the AF-4000 gas control
valves ON/OFF and flame height HI/LO of the main burner.
2.
When the ON button is depressed the transmitter sends a
RF signal to the module. The module then sends 3 volts of
power to the internal solenoid. The internal solenoid then
opens the gas flow to the main burner ON/OFF. The system
uses a pulse or continuous 3 volts DC power to operate the
flame HI/LO solenoid motor drive.
3.
The valve will light in the HI setting, then revert to the last
used setting. If the burner fluctuates between HI and LO, set
the burner to HI. After five minutes, set the burner to LO.
SPECIFICATIONS
BATTERIES: Transmitter 12V - (A23) Operating Frequency:
303.8 MHZ FCC ID No.'s: transmitter K9l1001
Canadian ISC ID No.'s: transmitter - 2439 102 728
Page 21
Hide quick links:
Advertisement
Table of Contents
