Advertisement
VersaBALL_User's_Guide_v1.9.qxd
10/7/2004
2:55 PM
Assembly Instructions
Check the parts list before assembling. If you are missing any parts please contact us. See back panel
for contact information. Thank you.
Before assembling the product read the following bulleted instructions:
·DO NOT INFLATE BALL FIRST.
·DO NOT INFLATE BALL OVER 65cm.
·DO NOT FULLY TIGHTEN BOLTS UNTIL PRODUCT IS FULLY ASSEMBLED.
·Tools are included for efficient assembly.
·Remove parts from bags and lay them out on a cleared area.
·Remove all packing materials and place them in box.
·Make sure all hardware is included.
Note: It is recommended that you apply grease to the threads of each bolt as you assemble the prod-
uct, to prevent loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts
are in place and partially threaded in before completely tightening any ONE bolt.
STEP 1
Assemble front support tubes and rear support tube to the upper ball ring. Make sure small tube ends
on the upper ring are facing up.
Note: Use BOLT C for the 2 front support tubes.
Note: Use BOLT B and 2 curved washers for the rear support tube.
BOLT B
REAR
BOLT C
Page 8
BOLT C
BOLT C
FRONT
7
Assembly Instructions
STEP 2
Connect base ring tube A to base ring tube B using 2 BOLT D's and 2 curved washers.
Assemble the upper ball ring front support tubes and rear support tube to the base ring.
The upper ring support tubes should slide over the base ring tubes.
Note: Use BOLT C for the 2 front support tubes.
Note: Use BOLT B and 2 curved washers for the rear support tube.
BOLT D
BOLT C
BOLT B
BOLT B
REAR
FRONT
BOLT D
BOLT B
BOLT D
BOLT C
8
BOLT C
Advertisement
