Advertisement
VersaBALL_User's_Guide_v1.9.qxd
10/7/2004
2:55 PM
Assembly Instructions
STEP 3
STEP 4
Page 7
BOLT B
Assemble seat receiver tube to upper ball ring
and base ring. The tube should fit on top of the
upper ring and over the bottom male connection
point. At this point only assemble the tube to the
upper ball ring using 1 BOLT B, 2 curved wash-
ers, and a nut.
Note: Assemble one bent washer on each side
of the bolt/nut connection point.
Also assemble pull-pin by turning the pull-pin bolt
clockwise.
Note: The pull-pin has a pulling and a locking
feature. To unlock the pull-pin twist the pullpin
counterclockswise.
Using 4 Bolt D's and 4 flat washers, assemble
seat adjustment tube to seat.
Note: Make certain to assemble the seat in the
correct direction. Seat adjustment tube holes
should be facing away from the machine.
See diagram.
BOLT D
9
Parts List
(A) M8x52 ALLEN BOLT (QTY 3)
(B) M8x45 ALLEN BOLT (QTY 3)
(C) M8x38 ALLEN BOLT (QTY 4)
(D) M8x16 ALLEN BOLT (QTY 11)
13/14 mm
HEX WRENCH
CURVED WASHER
QTY 19
FLAT WASHER
QTY 7
LOCK NUT
QTY 10
1.5 mm ALLEN
WRENCH
6
Advertisement
