Specifications; Attachments/Accessories; Operation; Think Safety First - Toro 04520 Operator's Manual

Specifications

Note: Specifications and design are subject to change
without notice.
Width of cut
Wheel tread
Wheel base
Overall length (w/baskets)
Overall width
Overall height
Net Weight w/reels (11 Blade)

Attachments/Accessories

A selection of Toro approved attachments and accessories are
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.
151 cm (59.5 inches)
128 cm (50.5 inches)
123 cm (48.6 inches)
249 cm (98.0 inches)
179 cm (70.62 inches)
205 cm (80.83 inches)
696 kg (1,535 lb)
22

Operation

Note: Determine the left and right sides of the machine
from the normal operating position.

Think Safety First

Please carefully read all of the safety instructions and symbols
in the safety section. Knowing this information could help
you or bystanders avoid injury.
The use of protective equipment, such as but not limited to,
for eyes, ears, feet, and head is recommended.

Checking the Engine Oil

The engine is shipped with oil in the crankcase; however, the
oil level must be checked before and after the engine is first
started.
Crankcase capacity is approximately 3.7 L (3.9 quarts) with
the filter.
Use high-quality engine oil that meets the following
specifications:
•
API Classification Level Required: CH–4, CI–4 or higher.
•
Preferred oil: SAE 10W–30
•
Alternate oil: SAE 15W–40
Toro Premium Engine oil is available from your distributor in
the 10W–30 viscosity. See the parts catalog for part numbers.
Note: The best time to check the engine oil is when the
engine is cool before it has been started for the day. If it has
already been run, allow the oil to drain back down to the
sump for at least 10 minutes before checking. If the oil level is
at or below the Add mark on the dipstick, add oil to bring the
oil level to the Full mark. Do not overfill. If the oil level is
between the Full and Add marks, no oil addition is required.
Important: Be sure to keep the engine oil level between
the upper and lower limits on the oil gauge. Engine
failure may occur as a result of over filling or under
filling the engine oil.
1. Position the machine on a level surface.
2. Remove the dipstick and wipe it with a clean rag (Figure
25). Push the dipstick into the tube and make sure it
is seated fully. Remove the dipstick from the tube and
check the level of oil. If the oil level is low, remove the
filler cap from the valve cover and slowly add enough
oil to raise the level to the Full mark on the dipstick.
Add the oil slowly and check the level often during this
process. Do not overfill.
Important: Make sure that the dipstick is removed
while filling the engine with oil. When adding
engine oil or filling oil, there must be clearance
between the oil fill device and the oil fill hole in the
valve cover as shown in Figure 24. This clearance