Toro 04520 Operator's Manual page 17

1
2
Figure 12
1. Suspension-arm bar
6. Close the latches down and around the cutting-unit bar
and lock them in place (Figure 11).
Note: A "click" can be heard and felt when the latches
are properly locked in place.
7. Coat the spline shaft of the cutting unit motor with
clean grease (Figure 13).
8. Insert the motor into the left side of the cutting unit
(as viewed from the operator's position) and pull the
motor retaining bar on the cutting unit toward the
motor until you hear an audible "click" from both sides
of the motor (Figure 13).
g01461 1
2. Cutting-unit bar
1
1. Reel motor
2. Spline shaft
9. Mount a grass basket onto the basket hooks on the
suspension arm.
10. Repeat this procedure for the other cutting units.
17
2 3
Figure 13
3. Cavity
4. Motor retaining bar
4
g014690